Search results
Results From The WOW.Com Content Network
The default gateway can be specified by the route command to configure the node's routing table and default route. In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices.
Default route. In computer networking, the default route is a configuration of the Internet Protocol (IP) that establishes a forwarding rule for packets when no specific address of a next-hop host is available from the routing table or other routing mechanisms. The default route is generally the address of another router, which treats the ...
COMMAND: The command to run (add, delete, change, get, monitor, flush)-net: <dest> is a network address-host: <dest> is host name or address (default)-netmask: the mask of the route <dest>: IP address or host name of the destination <gateway>: IP address or host name of the next-hop router
If a packet is sent to 203.0.113.1 by a computer at 192.168.1.100, the packet would normally be routed to the default gateway (the router) [e] A router with the NAT loopback feature detects that 203.0.113.1 is the address of its WAN interface, and treats the packet as if coming from that interface. It determines the destination for that packet ...
ipconfig. ipconfig (standing for " Internet Protocol configuration") is a console application program of some computer operating systems that displays all current TCP/IP network configuration values and refreshes Dynamic Host Configuration Protocol (DHCP) and Domain Name System (DNS) settings. [1] IPCONFIG.
Allow traffic to be routed between VLANs by providing a default gateway for the VLAN. Provide fallback bridging (if required for non-routable protocols). Provide Layer 3 IP connectivity to the switch. Support bridging configurations and routing protocol. Access Layer - 'Routed Access' Configuration (in lieu of Spanning Tree) SVIs advantages ...
Hot Standby Router Protocol. In computer networking, the Hot Standby Router Protocol (HSRP) is a Cisco proprietary redundancy protocol for establishing a fault-tolerant default gateway. Version 1 of the protocol was described in RFC 2281 in 1998. Version 2 of the protocol includes improvements and supports IPv6 but there is no corresponding RFC ...
The gateway is on the same network as end devices. The gateway address must have the same subnet mask as host devices. Each host on the network uses the same gateway. The gateway should have a static address, as changing the address would cause packets not to be delivered. The gateway is typically assigned either the highest or lowest network ...