Search results
Results From The WOW.Com Content Network
Internet Gateway Device Protocol. Internet Gateway Device ( UPnP IGD) Control Protocol is a protocol based on UPnP for mapping ports in network address translation (NAT) setups, supported by some NAT-enabled routers. It is a common communications protocol for automatically configuring port forwarding, and is part of an ISO / IEC Standard [1] [2 ...
This address is used by only one physical router at a time, and it will reply with this MAC address when an ARP request is sent for the virtual router's IP address. Physical routers within the virtual router must communicate within themselves using packets with multicast IP address 224.0.0.18 and IP protocol number 112 for IPv4, or ff02::12 and ...
Gateway Load Balancing Protocol. Gateway Load Balancing Protocol (GLBP) is a Cisco proprietary protocol that attempts to overcome the limitations of existing redundant router protocols by adding basic load balancing functionality. In addition to being able to set priorities on different gateway routers, GLBP allows a weighting parameter to be set.
A residential gateway is a small consumer-grade gateway which bridges network access between connected local area network (LAN) hosts to a wide area network (WAN) (such as the Internet) via a modem, or directly connects to a WAN (as in EttH ), while routing. The WAN is a larger computer network, generally operated by an Internet service provider .
In a home or small office environment, the default gateway is a device, such as a DSL router or cable router, that connects the local network to the Internet. It serves as the default gateway for all network devices. Enterprise network systems may require many internal network segments. A device wishing to communicate with a host on the public ...
The IP forwarding algorithm is a specific implementation of routing for IP networks. In order to achieve a successful transfer of data, the algorithm uses a routing table to select a next-hop router as the next destination for a datagram. The IP address of the selected router is known as the next-hop address. The IP forwarding algorithm states:
Default route. In computer networking, the default route is a configuration of the Internet Protocol (IP) that establishes a forwarding rule for packets when no specific address of a next-hop host is available from the routing table or other routing mechanisms. The default route is generally the address of another router, which treats the ...
In computer networking, the Hot Standby Router Protocol ( HSRP) is a Cisco proprietary redundancy protocol for establishing a fault-tolerant default gateway. Version 1 of the protocol was described in RFC 2281 in 1998. Version 2 of the protocol includes improvements and supports IPv6 but there is no corresponding RFC published for this version.